15.
Starting at Rear Corner, position a Solid Wall Panel
on top of plywood floor. The Wall Panel bottom framing
will sit flush with plywood. Wall siding will overhang the
floor.
Important:
Make sure all walls are aligned in their
upright position. If not ,water may leak into
your shed. Unsure if panel is facing up or
down? check siding on window wall panel
to match alignment.
16.
The rear wall panels will sit flush at the end
of the plywood floor with the sidewall panels will
be sandwiched between them.
Note:
Siding will overhang the floor by approx.
1/2”
Outside 2x3 framing of wall panel
is flush with outside of plywood
when properly aligned.
Rear Panel
Rear
Bottom Wall Plate
14.
Starting with
Solid Wall Panels
, carefully lay panel face down. Position and attach
Wall
Plate
to bottom of wall studs of each wall panel with 3 - 2 1/2” screws. Position so plates are flush
with framing.
Front
of
Shed
Toll Free 1-888-658-1658 www.outdoorlivingtoday.com [email protected]
Page 8