1010
10
Installation - Automated Hydraulic Steering Kit
Before installing, disconnecting or repairing the hydraulic hoses and components, turn off the machine and relieve all pres-
sure from the hydraulic system by turning the steering wheel left and right. Failure to remove the pressure can result in seri-
ous injury or death from unexpected machine movement.
To avoid burn injury when installing, disconnecting or repairing the hydraulic hoses and components, turn off the machine and
allow the system to cool down prior to touching the parts of the machine that are heated.
See Appendix B for a schematic of the hydraulic circuits.
1.
Prepare the hydraulic steering block.
Make sure the hydraulic steering block HA is clean
and dust free.
Remove the plastic plugs from hydraulic steering
block
HA
and install adapter fittings as follows
(Figure 1):
•
HB
in the
P
and
T
ports
•
HC
in the
A
and
B
ports
•
HD
in the
LS
port
2.
Install the steering block mounting bracket.
Using hydraulic steering block bracket
HE
as a
template mark the inner face of the left rear fender
(Figure 2) 8
”
from the bottom of the fender (Figure
2 left inset - outer face view) and just back from the
fender’s front edge. Drill two 7/16
”
holes and,
using hardware
HG
, attach bracket
HE
(Figure 2,
right inset).
3.
Install the hydraulic steering block and steering
controller mounting bracket.
Using hardware
HF
, attach hydraulic steering block
HA
and steering controller bracket
HH
to bracket
HE
(Figure 3):
• Mount
HH
against
HE
with its short side
upward and outward (from mounting)
• Mount
HA
with its L/R solenoids upward (so
with the
P
and
T
ports rearward)
Figure 1: Prepared hydraulic block
Figure 2 with insets: Steering block mounting
bracket location and installation
Figure 3: Steering block and steering controller
mounting bracket installed
HB
HD
HC
HA
Install HE here
HE
8
”
HG
HH
HE
HF
L/R solenoids
P and T ports
