Outback EDX-VD6, Руководство пользователя

Страница: 14 / 20

1414
14
2. Mount the wheel angle sensor.
Figures in this section show a prototype WAS
assembly mounting bracket. Install your supplied
bracket (WK) as described.
a. Locate and remove the fuel tank’s top mounting
bolt on the right side of the rear of the front section
of the machine (Figure 2a, top inset). Retain the
nut. Using hardware
WM with the machine’s nut,
install WAS bracket WK (Figure 2a, bottom inset)
with its long arm inward and parallel to the ground
(Figure 2a).
b. Locate the two outer (leftmost) holes in the bottom
of the articulation coupling (Figure 2b) and, using
hardware
WN (Figure 2b, bottom left inset), install
link rod bracket WL , its long arm pointing inward
(Figure 2b, top right inset).
c. Using hardware WJ (not visible), mount the WAS
assembly from step 1 on the rear face of bracket
WK. Mount the WAS assembly with its arm WC
on top and, like wire connector WB , pointing out-
ward (Figure 2c).
d. Using hardware WH, install the link rod assembly
from step 1 between the last hole in WAS arm WC
and bracket WL . Set the swivel stud downward into
WC and upward into WL (Figure 2d - leave swivel
nuts WH loose until you complete linkage adjust-
ment at step 2f.).
Figure 2a with insets: Installed WAS mount-
ing bracket (prototype bracket shown installed)
Figure 2b with insets: WAS link rod bracket in-
stalled
Figure 2c: Installed WAS assembly
Figure 2d: Installed WAS link rod assembly
Use WK
WM
WN
WL
WAS assembly
(WJ)
WB
WC
(Your)
WK
WH
Link rod assembly
WC
WL