Otto P 600 B-2, Руководство пользователя

Страница: 13 / 55

13
Manual CSG II Series - English
9- EXTRAORDINARY MAINTENANCE
to be carried out by the maintenance operator / dealer
• Material holder tube gaskets replacement:
after extensive use air leakages on the back of the material holder tube may occur.
The outlet OR needs to be replaced. Contact your dealer.
• Replacement of the piston lip gasket (also for CSG II 450 thrust piston):
after extensive use an excessive waste of the thrust
piston lip seal may occur, thus leading to a lower performance and air leakage on the front of the machine. The lip seal needs to be
replaced. Contact your dealer.
10- FAULTS AND BREAKDOWNS
to be carried out by the maintenance operator / dealer
In the event of faults and/or breakdowns of gun components, do not try to repair them. Do not use the gun with temporary
repairs or damaged or worn out components, or with non-original components used as a replacement. Repairs shall be carried
out by authorized workshops or directly by the manufacturer. Contact your dealer.
11- FREQUENT ISSUES
12 - WARRANTY
The machines and their tools are covered by the warranty, if not subject to wear and tear, in compliance with European regu-
lations. All components deemed faulty will be replaced by our technical department with no charges, only if returned without
tampering or stains and if delivered DDP to our plant. The manufacturing company is not liable for personal injuries or damage
to property due products or gun misuses, which are expressly forbidden by this manual. In addition the company recommends
to carefully comply with the user’s instructions. The sale of disassembled, altered or incomplete machines or tools (upon specific
request of the client) is not covered by warranty as our technical department could not test and approve them.
INCONVENIENTS
CAUSES REMEDIAL ACTIONS
After charging the material and connecting
the machine to the system, nothing occurs
when pushing the lever. No feeding. Check disconnector opening on the system. Check pressure
regulators. Check for potential leakages in the tube.
Irregular or slow extrusion Very thick product. Increase air capacity with the flow regulator. Increase air pressure
with the pressure regulator.
Loss of pressure and extrusion power of
the machine. Slow front ring nut. Damaged
cartridge lip
Tighten the ring nut properly. Check cartridge user’s instructions.
Replace the damaged cartridge.
The machine does not work properly. Damaged or dirty components. Carry out cleaning and ordinary maintenance operations. If the issue
is due to damaged components, contact your dealer.
Ordinary maintenance
FREQUENCY OPERATION DESCRIPTION
Every 2 weeks Threads greasing Grease the ring nut thread (2) as well as the relevant cartridge holder tube thread, with
lubricating grease.
Every week Material holder tube inner greasing Grease the material holder tube inner surface with a brush.
Every 2 weeks Dusts, filth or material residues Carefully clean the front ring nut thread (2) and the relevant cartridge holder tube thread with a
clean cloth and a detergent.
Every 2 weeks Dusts or filth Carefully clean the connector between the machine and the feeding system with a clean cloth
and a detergent.
Every month Dusts or filth Carefully clean the machine, with a clean cloth and a detergent, especially the handle, as ease of
holding is a priority.
Every 2 weeks
(CSG II 450 only) Transmission bar greasing After removing the material holder tube carefully clean the transmission bar. Manually move
forward the piston twice.
* Time slots are to be intended as actual working time.