Otto Bock RS2-K1 Runway HX, Инструкция по эксплуатации

Страница: 10 / 36

RS2-K1 Runway® HX 10 |
Runway® HX Instruction for Use
Product Number: RS2-K1
Instructions for Use (R-720-092, Rev. J)
Page 3 of 4
English EU
• Remove the foot shell and Spectra™ sock to adjust the ankle shims.
• Ensure ankle assembly is clean and appropriately lubricated before adjustment.
• Use a 1/8” hex wrench (provided) to tighten slide adjustment screws located on
the underside of the pyramid slide.
• Tighten each screw until firm resistance is felt, then loosen until resistance to
slide movement is minimal.
• Check slide action after each shim is adjusted.
• If shims are loose, the ankle may make noise when walked. If shims are too
tight, the ankle mechanism will be difficult to adjust. (See Figure below)
•
Maintenance
(User)

Use soap and warm water to clean and/or disinfect the foot shell.

Wet or dirty environments may cause the ankle module to malfunction and make it
difficult to operate.
o If the ankle module is exposed to wet or dirty environments, it is
recommended to periodically clean and lubricate the module in order to
minimize impact on module performance.

Disassemble from shell, rinse with fresh water and thoroughly dry.

If corrosion or buildup has occurred, clean the ankle mechanism
with solvent (i.e., acetone, WD-40) and compressed air.

Cycle the mechanism thru the entire range while cleaning.

Lubricate the slide with light grease, or spray lubricant and wipe off
excess.

Have the foot module serviced at the intervals specified by the prosthetist.
Shim
Shim adjustment screw
Runway® HX Instruction for Use
Product Number: RS2-K1
Instructions for Use (R-720-092, Rev. J)
Page 4 of 4
English EU
Warnings
 Wet or dirty environments may cause the ankle module to malfunction and make it
difficult to operate.

Never allow aggregates such as sand to remain in the foot shell.

If the ankle module is exposed to wet or dirty environments, it is recommended to
periodically clean and lubricate the module in order to minimize impact on module
performance.
o Disassemble from shell, rinse with fresh water and thoroughly dry.
o
If corrosion or buildup has occurred, clean the ankle mechanism with solvent
(i.e., acetone, WD-40) and compressed air.
o Cycle the mechanism thru the entire range while cleaning.
o Lubricate the slide with light grease, or spray lubricant and wipe off excess.

Always use the foot with a foot shell. Failure to comply may cause premature wear,
loss of function, and/or product failure.
 Always use the foot with a sock and shoe. Failure to comply may cause noise,
premature wear, loss of function, and/or product failure.
 Do not attempt to adjust the ankle while standing, without a grab rail or other
appropriate fixed object for support.

Never attempt to loosen the bolts affixing the ankle mechanism to the keel.

Discontinue use and consult prosthetist if prosthesis starts to make any noise.
 Do not share your prosthesis with others; it may cause damage to the device and/or
injury.

Inform your prosthetist if you lose or gain a significant amount of weight.
4519104.indd 10 06.04.2021 08:27:55