OSTBERG HERU 1200 S EC, Руководство по установке

Страница: 42 / 72

42
OPERATION INDICATION
Operation indicator indicates by closing (NO), when the HERU ® CX unit is in
operation. Max load is 230V AC / max 6A.
Operation indication is connected as follows:
ALARM INDICATION
There are two alarm outputs on HERU ® CX; indication through closing of output at
signal.
– Alarm A - operation stops.
– Alarm B - HERU ® CX operation is not stopped, only information in HMI
and the Alarm B output indicate that something is wrong.
Alarm A can be described as Danger or High alarm class in the HMI.
Alarm B can be described as Low alarm class.
Max load is 230V AC / max 2A.
Alarm indication is connected as follows:
Signal output for alarm indications can be function reversed (i.e. changed to NC).
This is done under
Unit > Outputs.
For more information or assistance, see Climatix Basic Documentation.
AUX OPERATION INDICATION
AUX operation indication is a selectable indication.
The following functions can be chosen for indication on the AUX output:
Parameternamn Beskrivning av indikeringen
Off Switched off.
Supply/Comf Comfort mode (Temperature setpoint comfort).
Economy Economy mode (Temperature setpoint economy).
Osstp Not applicable for HERU
®
CX
Night cooling Night cooling enabled (in operation).
Support operation Support operation; heating and/or cooling enabled (in operation).
Test Temp Temperature test enabled for updating of duct sensor temperature.
Damper exercise Not applicable for HERU
®
CX
Fire Fire mode (function dependent on the parameter setting for fire mode).
Stop Unit stopped and locked (controller in start phase, configuration not completed,
alarm class danger, emergency stop).
Cool down Cool down.
Start-up Unit’s start routine enabled.
Full heat The heat output signal has reached 100 %
Full recovery The recovery output signal has reached 100 %
Full cooling The cooling signal has reached 100 %
Max load on the output is 230V AC / max 2A
AUX operation indication is connected as follows:
Signal output for AUX operation indicators can be function reversed (i.e. changed to
NC). This is done under
Unit > Outputs.
For more information or assistance, see Climatix Basic Documentation.
INDICATIONS FOR EXTERNAL SIGNALS
31
32
37
38
9.27
9.28
9.29
33
34
35
36
A-alarm
B-alarm
1270466_utg3_HERU_400_1200_eng.indd 42 2020-10-28 11:59:47
1270466_utg3_HERU_400_1200_eng.pdf 42 2020-10-28 12:04:20