SECTION 3 - MACHINE CONTROLS AND INDICATORS
31215054
3-15
NOTE:
When positioned to Manual, boom functions will be stopped
when the envelope limits are reached. When this occurs, operate
a different function or select the automatic position.
NOTE:
Depending upon the angle of the chassis and the angle of the
boom, swing left or swing right may be disallowed while in the
Manual mode. The BCS light will illuminate and further attempts
to swing in the disallowed direction will cause the BCS to flash.
When this occurs the only choices are to swing in the opposite
direction or switch to automatic mode.
8.
Power/Emergency Stop
A two-position red mushroom shaped switch
supplies power to Platform Controls when
pulled out (on). When pushed in (off), power is
shut off to the platform controls.
9.
Start/Auxiliary Power
When pushed forward, the switch energizes the
starter motor to start the engine.
When pushed back, it energizes the electrically
operated hydraulic pump, when actuated. (Switch
must be held on for duration of auxiliary pump
use.)The auxiliary pump functions to provide suffi
-
cient oil flow to operate the basic machine functions should
the main pump or engine fail. The auxiliary pump will oper
-
ate platform rotate, jib lift, jib level, jib telescope, jib stow,
platform level, main boom lift, main telescope and swing.
10.
Capacity Select Switch
This switch allows the operator to select
between an operating envelope with a 500 lb
(227 kg for ANSI markets and 230 kg for CE
ans Australia markets) capacity restriction or
a 1000 lb (454 kg for ANSI markets and 450 kg for CE and
Australia markets) capacity restriction.
11.
Drive Orientation Override
When the boom is swung over the rear tires
or further in either direction, the Drive Orien
-
tation indicator will illuminate when the drive
function is selected. Push and release the
switch, and within 3 seconds move the Drive/Steer control
to activate drive or steer. Before driving, locate the black/
white orientation arrows on both the chassis and the plat
-
form controls. Move the drive controls in a direction match
-
ing the directional arrows for the intended direction of
travel.
Содержание JLG 1200SJP
