Orthman 125-082-01-EN-OM, Руководство оператора, Страница: 78 / 86

MAINTENANCE AND SPECIFICATIONS
1TRIPR II Row Units OM-EN
7-4
Lubrication
To reduce maintenance, the 1tRIPr® II Row Units are
completely greaseless. However, lubrication is an
important part to prolonging the life of implement
components. See the Orthman toolbar operator manual
for lubrication service intervals and zerk locations.
The purpose of lubrication on machines with moving
parts is to prevent metal-on-metal contact.
Metal-on-metal contact creates premature wearing of the
connective components. Premature wearing of
connective components can lead to non-warrantable,
catastrophic failure of a machine.
During the off-season, moisture and dust can
contaminate grease in moving points of a machine that
are not sealed, such as pins. This can lead to seized
pins. For this reason, machine lubrication points should
always be lubricated with grease before first time use.
Always use clean, high-quality grease for lubricating
machine. The grease should be selected on the basis of
the environment the machine will operate in, such as
temperature, humidity, etc.
Chains also need adequate lubrication. Lubrication
allows a chain to move smoothly with reduced friction
and prevents premature stretching of the chain.
Implement Inspection
Before each use, inspect implement for damaged or
broken parts. Replace broken or worn parts immediately.
When replacement parts are necessary for periodic
maintenance and servicing, genuine factory replacement
parts must be used in order to restore the implement to
original specifications. Contact your Orthman dealer for
replacement parts.
During break-in (40 hours), check hardware for proper
torque every 10 to 20 hours. See “Torque Specifications”
on page 7-2. Before each use, check hardware for wear
and proper torque. Replace damaged or missing
hardware with hardware of an identical grade to restore
the implement to original specifications.
Remove any buildup of grease, oil, and debris.
Replace all shields and guards. Be sure all tools, parts,
and service equipment are removed before you operate
the implement.
Implement Storage
Prior to storing the implement for a long period of time,
perform the following:
• Restore the 1tRIPr® II Row Units to shipping
configuration. For more information, see “Shipping
Configuration” on page 4-2.
• Clean and touch up paint seasonally to avoid
corrosion and rust. Contact your Orthman dealer for
touch up paint.
• Inspect all safety decals and replace if missing or
damaged. Contact your Orthman dealer for
replacement decals. See “” on page 2-9.
• Grease all zerks regardless of hourly interval. See
“Lubrication” on page 7-4.
• Check all hardware according to torque
specifications. See “Torque Specifications” on
page 7-2.
• Inspect implement for damaged or broken parts.
Replace parts as necessary.
• Remove any buildup of grease, oil, and debris.
Store inside if possible. Storing the implement inside will
prolong the life of the components.
DANGER
!
Avoid crushing. Failure to follow this information will
result in death or serious injury. Use bar stands and
cylinder stops to support the implement.
Store the implement on a clean, dry, level surface. An
uneven surface could cause the implement to shift or fall,
resulting in injury or death as well as implement damage.
Securely support all implement components that must be
raised. Store the implement away from human activity.
DANGER
!
Avoid crushing. Failure to follow this information will
result in death or serious injury. Make sure all personnel
are clear of the implement before lowering.
Lower the implement to the ground, place the tractor in
park, turn off the engine, and remove the key.