
OPERATION AND FIELD SETTINGS
1TRIPR II Row Units OM-EN
5-23
This table has been created to help understand the
effects that the set bolt and spring tension setting have
on the AR trip linkage’s ability to trip. The numbers
shown in the chart represent the estimated amount of
force (lb/kg) that is required to trip the tail when the shank
is at the deepest setting.
As the spring tension is increased (tightened up) and the
set bolt setting is decreased (unscrewed), the force
required to trip is increased.
ORM000300
Figure 5-18: Set Bolt Setting
Orthman Manufacturing encourages the operator to start out
at the factory setting, where the row unit tail will trip very
easily. From that point adjust the set bolt and spring tension
to attain the desired AR trip linkage setting.
The standard version of the 1tRIPr® II without the AR trip
linkage is equipped with a shear bolt. See “Shear Bolt
Protected Tail” on page 5-20. The amount of force it takes to
shear this bolt is slightly over 8000 lb (3629 kg).
*Notice that the chart has values that exceeds 8000 lb
(3629 kg). Orthman Manufacturing recommends using
extreme caution when adjusting the AR trip linkage to a
setting above 8000 lb (3629 kg). Using a setting that exceeds
the 8000 lb (3629 kg) mark is likely to increase the chances
of damaging the shank in the event an obstacle is
encountered.
Spring Tension Setting
Distance
1-3/16
(3.02 cm)
1 in
(2.54 cm)
7/8 in
(2.22 cm)
Set Bolt Setting
4-1/2 full turns in
1/4 in
(0.64 cm)
3352 lb
(1520 kg)
6331 lb
(2872 kg)
6703 lb
(3040 kg)
3-1/4 full turns in
3/16 in
(0.48 cm)
4096 lb
(1858 kg)
6889 lb
(3125 kg)
7076 lb
(3210 kg)
2-1/4 full turns in
1/8 in
(0.32 cm)
4841 lb
(2196 kg)
7262 lb
(3294 kg)
7262 lb
(3294 kg)
1 full turn in
1/16 in
(0.16 cm)
5958 lb
(2703 kg)
7448 lb
(3378 kg)
*8193 lb
(3716 kg)
0 turns
0 in
(0 cm)
*8565 lb
(3885 kg)
*8938 lb
(4054 kg)
*9682 lb
(4392 kg)
13) Stop block
16) Set bolt
14) Rear trip link
17) Set bolt setting
15) Jam nut
13
17
14
15
16
Содержание 125-082-01-EN-OM
