Orolia Spectracom VersaPNT, Руководство по началу работы

Страница: 35 / 46

Header Output Type
RMC Recommended Minimum Specific Data
THS True Heading and Status
ZDA Time & Date
In order to output NMEA messages, you must configure both the settings in this NMEA
Output tab, AND the pinout configuration of the Multi I/O connector. NMEA Out is only
available on Channel 4 (see
"Assigning I/O Pins" on page 23 ).
2.4.2 "Calibration" Tab/Antenna Installation
Single Antenna Installations
Should only one GNSS antenna be used, the antenna can be installed at any location on
the vehicle with an unobstructed view of the sky.
Antenna 1 Offset X : [m] The X-offset from the X-Y-Z etching on the VersaPNT lid
to the GNSS antenna number 1.
Antenna 1 Offset Y : [m] The Y-offset from the X-Y-Z etching on the VersaPNT lid
to the GNSS antenna number 1.
Antenna 1 Offset Z : [m] The Z-offset from the X-Y-Z etching on the VersaPNT lid
to the GNSS antenna number 1.
Dual Antenna Installations
Note: Installations using two antennas are only available on models with a
GPS Compassing IMU unit, special ordered and pre-installed at the factory.
2.4 INS Configuration
VersaPNT Getting Started Guide Rev. 3.0 31