Ormed Artromot-F, Руководство по эксплуатации

Страница: 23 / 34

– Place the splint (12) on the forearm
with the distale end of the splint
extending to the middle of the MP
joints.
– Form the sides of the splint (12) to
adapt them to the contours of the
forearm and hand.
– Tighten the splint (12) onto the fore-
arm and hand with the Velcro straps
(13 /14).
– Loosen the splint clamp (3) under-
neath the actuator housing (1) by
turning it several times.
– Slide the CPM actuator onto the
splint’s mounting bracket (15) and
adjust the CPM actuator distally or
proximally along the mounting
bracket.
– Correctly position the actuator so
that the center of large round hinge
(10) aligns with the center of the MP
joints.
– To accommodate various patient size,
the CPM actuator (11) adjusts proxi-
mally and distally, and laterally and
medially.
– First, apply the fully-adhesive side of
the VHB Pad (17) to the underside of
the finger clip (16).
– Next, peel the label off the adhesive
portion of the VHB Pad and place
the adhesive portion onto the finger
nail.
– Pay attention that the finger clip (16)
aligns with the end of the finger.
– Peel and wrap a finger strip (18)
around the finger and finger clip (16)
to complete the attachment. (fig.1)
– The finger actuators are easily
designed to clip in and out of the
finger clips (16).
– To attach the finger actuators (7/8),
pinch together the “V”-clamps (9)
at the end of the finger actuators and
roll into the finger clips. (fig. 2)
– Make sure, you hear it engage and the
“V”-clamps are secure.
21
4.1 Adjusting the device
for the finger treat-
ment
†
Attaching the Splint
4. Adjusting the device
Œ
Attaching and positioning the
CPM actuator
Å
Attaching finger clips (16) and
finger actuators (7/8)