RGPS-92222GCP-NP Series User Manual
ORing Industrial Networking Corp.
117
Period
checkbox is checked. Valid range of the value is 1 to 3600 seconds.
EAPOL
Timeout
Determines the time for retransmission of Request Identity EAPOL frames.
Valid range of the value is 1 to 65535 seconds. This has no effect for
MAC-based ports.
Age Period
This setting applies to the following modes, i.e. modes using the
Port
Security
functionality to secure MAC addresses:
MAC-Based Auth
.:
When the NAS module uses the Port Security module to secure MAC
addresses, the Port Security module needs to check for activity on the MAC
address in question at regular intervals and free resources if no activity is
seen within a given period of time. This parameter controls exactly this period
and can be set to a number between 10 and 1000000 seconds.
For ports in
MAC-based Auth.
mode, reauthentication does not cause direct
communications between the switch and the client, so this will not detect
whether the client is still attached or not, and the only way to free any
resources is to age the entry.
Hold Time
This setting applies to the following modes, i.e. modes using the
Port
Security
functionality to secure MAC addresses:
MAC-Based Auth
.:
If a client is denied access - either because the RADIUS server denies the
client access or because the RADIUS server request times out (according to
the timeout specified on the "
Configuration
→
Security
→
AAA
" page) - the
client is put on hold in Unauthorized state. The hold timer does not count
during an on-going authentication.
The switch will ignore new frames coming from the client during the hold
time.
The hold time can be set to a number between 10 and 1000000 seconds.
Port
The port number for which the configuration below applies
Admin
State
If NAS is globally enabled, this selection controls the port's authentication
mode. The following modes are available:
Force Authorized
In this mode, the switch will send one EAPOL Success frame when the port
link is up, and any client on the port will be allowed network access without
authentication.
Force Unauthorized
In this mode, the switch will send one EAPOL Failure frame when the port
