GB
- E 32 -
9600-GB GETR UMDR (353)
TURN GEARING ROUND
Preparation
• Safety advice: see Supplement A1, pts. 1- 3 and 8.
• Only lift loads using lifting equipment with sufficient
load capacity dimensions and stability.
Setting required driving motor speed
Possible are:
- 540 r.p.m.
- 1000 r.p.m.
• Check the necessary r.p.m.:
Driving motor
Intermediate
Driving motor
stub (9)
shaft (10)
speed
1 revolution 1.3 revolutions 540 r.p.m.
1 revolution 0.75 revolutions 1000 r.p.m.
When only one revolution is possible on tractor and this does
not agree with driving motor speed:
Turn gearing round
- Disconnect intermediate shaft (1): see accompanying
drive shaft instruction manual.
- On both sides:
- Remove safety chain.
- Dismount protection and slide back.
- Unlock: push locking pin in and hold.
- Remove drive shaft.
1
TD24/95/9
2
3
6
7
TD24/95/10
10
9
- Support drawbar (2).
- Loosen the 16 fastening screws (3).