337 / WARTUNG / 9800-GB
Maintenance
- 17 -
GB
Checking the mowing blade suspension
- Check immediately after driving over a hard obstacle.
- Normal check every 100 hours.
- Check more often when mowing on rocky terrain.
Mower disc
With mower discs that
are worn in the mowing
blade area, you must
proceed as follows:
- Remove lower support
disc.
- Kunststoffklappe
entfernen.
- Remove cutter holder
nuts.
- Shift cutter holder
around 1 hole (60
o
).
- Tighten screws firmly
(120Nm) and re-check
after a few hours of operation.
- Re-mount mowing blades.
V-belt tension
After the first hours of operation
- Check or adjust V-belt tension:
After changing V-belts:
Basic adjustment:
- Disc (1) to approx. top control measurement (2).
- Secure with lock nut (3).
WINTER STORAGE
- Driving belts should be slackened throughout the winter.
Gearing
- Change oil after the first 50 hours of operation.
- Under normal operating conditions, oil is to be
topped-up annually.
- Change oil after 300 ha at the latest.
Cutter bar-oil change
TD 32/95/4
300 ha
1 x jährlich (300 ha)
1 fois par an (300 ha)
once a year (300 ha)
1 x per jaar (300 ha)
(III)
13 Liter
Oil level 2,5 - 3,5 cm
Ölstand 2,5 - 3,5 cm
Niveau d' huile 2,5 - 3,5 cm
Cutters
The cutters on a cutting drum should be evenly
worn out, (danger of imbalance) otherwise they
are to be replaced by new ones.
Pay attention to correct assembly!
- Cutters with the
notation “L” are only
to be mounted on the
left rotating mowing
drum.
- Cutters with the
notation “R” are only
to be mounted on the
right rotating mowing
drum.
Changing the cutters
- Prop up the lever (29) on the lower edge of the drum and push
the moveable holder (30) downwards. The cutter (14) is hung
on the bolt (31).
- Change the cutters and clean all forage away that the cutter
held from around the bolt. Perhaps the inner side of the drum
also.
- Remove the lever (29) and
check if the cutter holder
bolt (31) has returned to its
original position and if the
cutter can move freely on
the bolt.
- When the bolt (31) is
greatly worn, the holder
(30) should be replaced.
+
-
+
-
TD24/95/35
1
4
3
2
R
L
TD 32/95/5