OPTIMOD-PC INSTALLATION
2-37
Problems and Possible Causes
Always verify that the problem is not the source material being fed to OPTIMOD-PC,
or in other parts of the system.
When I first turn on my computer, the sound seems wrong.
This is normal. Upon boot, the OPTIMOD-PC driver loads a “placeholder” preset and
I/O setup into the OPTIMOD-PC’s DSP so that the card will pass audio. After the
OPTIMOD-PC Service application starts (as part of the computer’s boot sequence), it
will automatically load the last active preset and I/O setup.
The driver does not restore the Processing Delay, AGC, and I/O Lowpass
Filter Configuration parameters at startup. They are restored at startup if
the OPTIMOD-PC service is being started automatically. If the OPTIMOD-
PC service is not being started automatically, these parameters will be re-
stored when the OPTIMOD-PC Control application is launched.
All others IO settings are restored when the driver loads.
When I Launch the OPTIMOD-PC control application, the meters do not move and I
cannot control my card.
Unless you have only one OPTIMOD-PC card installed in your computer, you must
connect the application to a given card (via the
C
ONNECT
Menu item) before you can
control it. This is because the Control Application is designed to address more than
one card in multi-card installations. See the steps starting with step 4 on page 2-6.
I can’t connect to a given OPTIMOD-PC card from my network.
You must check the
A
LLOW
N
ETWORK
T
O
A
CCESS
L
OCAL
C
ARDS
box in the
C
ARDS
A
ND
S
ECURITY
A
DMINISTRATION
dialog box for that card.
Other possible causes are:
Содержание OPTIMOD-PC 1100
