OPTIMOD-PC INSTALLATION
2-25
sibilance and cymbals. The cure is lowering the
L
IMITER
D
RIVE
control un-
til the problem is no longer audible.
If you find that lowering the
L
IMITER
Drive causes too much loudness
loss, you can use the Band 5 compressor as a high frequency limiter to
compromise between loudness and limiting artifacts. Set
B5
D
ELTA
R
ELEASE
to
+6
and
B5
S
TEREO
C
OUPLING
to
O
FF
.
Adjust
B5
T
HRESHOLD
con-
trol until you see gain reduction on the Band 5 GR meter with problem-
atic material. Continue to lower the
B5
T
HRESHOLD
control until you no
longer hear gain pumping. Instead, you will probably hear some high
frequency loss. This loss is less subjectively objectionable than gain pump-
ing.
You can use the
AGC+LIMITER
factory presets as an example of how to
do this. See
AGC+[FLAT, 50
µ
s, 75
µ
s] LIMITER
on page 3-18.
Input Setup
There are two input mixers in the I/O Mixer: the
P
ROCESSOR
M
IXER
and the
D
IRECT
M
IXER
(see Figure 2-7).
•
The Processor Mixer drives the input of OPTIMOD-PC’s audio processing.
•
The Direct Mixer drives the direct input of OPTIMOD-PC’s Output Routing
Switcher.
Figure 2-7: Processor Mixer Page in I/O Mixer
Содержание OPTIMOD-PC 1100
