Oracle SG-SAS6-INT-Z, Руководство по установке, Страница: 21 / 80

To Complete the Installation
3.
If you need to install an OS on your system, complete the procedures in
Chapter 3, “Creating a Bootable Drive in a Preboot Environment ” and then go to
the next step.
4.
If you already have an OS installed on an x86 system, review the BIOS bootup
messages to ensure that you see the LSI BIOS initialization banner and that you
are prompted for the BIOS utility (by pressing
Ctrl+C
).
If you see the banner and are prompted for the utility, it means the BIOS has detected the HBA
card.
5.
If you already have an OS installed on a SPARC system, during the power-
up process of the system, use the
probe-scsi-all
command at the Open Boot
Prompt (OBP)
ok
prompt to verify that the system recognizes the HBA.
The
probe-scsi-all
command displays the SCSI devices that are connected to the host, as
shown in the following example.
{0} ok probe-scsi-all
/pci@0/pci@0/pci@8/pci@0/pci@a/LSI,sas@0
MPT Version 2.00, Firmware Version 4.00.00.00
Target 9
Unit 0 Disk SEAGATE ST914602SSUN146G0603 286739329 Blocks, 146 GB
SASAddress 5000c5000b305b4d PhyNum 0
Target a
Unit 0 Disk SEAGATE ST914602SSUN146G0603 286739329 Blocks, 146 GB
SASAddress 5000c5000b304cad PhyNum 1
Target b
Unit 0 Disk HITACHI H101414SCSUN146GSA23 286739329 Blocks, 146 GB
SASAddress 5000cca000310015 PhyNum 2
Target c
Unit 0 Disk HITACHI H101414SCSUN146GSA23 286739329 Blocks, 146 GB
SASAddress 5000cca0002cf035 PhyNum 3
{0} ok
This example shows a SAS 2 controller (
LSI,sas@0
) connected to four physical drives.
6. (Optional) If you would like to create additional RAID volumes on the system
(maximum of two RAID 0, 1, and 10 volumes per system), follow either Step 6a or
Step 6b , then continue with Step 6c :
a. (SPARC only) During the power-up process of the system, access the OBP
and create RAID volumes for the HBA by issuing the appropriate
FCode
commands.
Chapter 2 • Hardware Installation and Removal 21