43
LTDVE4CH-20 | INSTRUCTIONS MANUAL
14.2.26. Register ETH_DHCP_ENABLE
Bit 0 of this register holds the enable flag for the DHCP.
When set to 0 the DHCP is disabled (default value)
When set to 1 the DHCP is enabled
Bit field [15:1] of this register is unused. When writing these bits, they must be set to zero.
14.2.27. Register ETH_IP_ADDR_HI
This register contains the sixteen high order bits of the IP address for Ethernet
communication of the
controller. These are the bits [31:16]. The default IP address is
192.168.0.32.
The factory settings can be restored using the INIT button (see
of the
INIT button functionalities).
14.2.28. Register ETH_IP_ADDR_LO
This register contains the sixteen low order bits of the IP address for Ethernet
communication of the
controller. These are the bits [15:0]. The default IP address is
192.168.0.32.
The factory settings can be restored using the INIT button (see
of the
INIT button functionalities).
14.2.29. Register ETH_SUBNET_MASK_HI
This register contains the sixteen high order bits of the subnet mask for Ethernet communication of
the controller. These are the bits [31:16]. The default subnet mask is 255.255.255.0.
The factory settings can be restored using the INIT button (see
INIT button functionalities).
14.2.30. Register ETH_SUBNET_MASK_LO
This register contains the sixteen low order bits of the subnet mask for Ethernet communication of
the controller. These are the bits [15:0]. The default subnet mask is 255.255.255.0.
The factory settings can be restored using the INIT button (see
INIT button functionalities).
14.2.31. Register ETH_DEF_GATEWAY_HI
This register contains the sixteen high order bits of the default gateway for Ethernet communication
of the controller. These are the bits [31:16]. The default gateway is 192.168.0.1.
The factory settings can be restored using the INIT button (see
INIT button functionalities).
14.2.32. Register ETH_DEF_GATEWAY_LO
This register contains the sixteen low order bits of the default gateway for Ethernet communication
of the controller. These are the bits [15:0]. The default gateway is 192.168.0.1.
The factory settings can be restored using the INIT button (see
INIT button functionalities).
14.2.33. Register ETH_PRI_DNS_HI
This register contains the sixteen high order bits of the primary (preferred) DNS address for
Ethernet
communication of the controller. These are the bits [31:16]. The primary DNS address is 192.168.0.2.