opto engineering LTDVE4CH-20, Инструкция по эксплуатации

Страница: 40 / 69

39
LTDVE4CH-20 | INSTRUCTIONS MANUAL

When 0x0000004 pulse generator 3 output is selected

When 0x0000008 pulse generator 4 output is selected

When 0x0000010 pulse generator 5 output is selected

When 0x0000020 pulse generator 6 output is selected

When 0x0000040 pulse generator 7 output is selected

When 0x0000080 pulse generator 8 output is selected

When 0x0010000 filtered input TR1 is selected

When 0x0020000 filtered input TR2 is selected

When 0x0040000 filtered input TR3 is selected

When 0x0080000 filtered input TR4 is selected

When 0x1000000 the output is always active (continuous)
Bit fields [15:9] and [7:4] of these registers are unused. When writing these bits, they must be set to
zero.
14.2.14. Registers OUTPUT_SEL_LO[0:3] and OUTPUT_SEL_LO[8:11]
The output multiplexers are used to route the internal signals to the light outputs and synchronization
outputs. Each output multiplexer has an independent selector.
The selector of a specific output multiplexer is a 25 bits binary number, split on a pair of contiguous
Modbus registers named
OUTPUT_SEL_HI [x] and OUTPUT_SEL_LO [x].
Registers OUTPUT_SEL_HI [x] hold in bit fields [8:0] the nine high order bits of the selectors, while
registers OUTPUT_SEL_LO [x] hold the remaining sixteen low order bits of the selectors.

OUT_SEL_LO0 : lower sixteen bits of output multiplexer 1 selector (light LD1)

OUT_SEL_LO1 : lower sixteen bits of output multiplexer 2 selector (light LD2)

OUT_SEL_LO2 : lower sixteen bits of output multiplexer 3 selector (light LD3)

OUT_SEL_LO3 : lower sixteen bits of output multiplexer 4 selector (light LD4)

OUT_SEL_LO8 : lower sixteen bits of output multiplexer 9 selector (sync. output SH1)

OUT_SEL_LO9 : lower sixteen bits of output multiplexer 10 selector (sync. output SH2)

OUT_SEL_LO10 : lower sixteen bits of output multiplexer 11 selector (sync. output SH3)

OUT_SEL_LO11 : lower sixteen bits of output multiplexer 12 selector (sync. output SH4)
Allowed values for the selectors of the output multiplexers are listed in section 14.2.13 , along with a
description of the OUTPUT_SEL_HI [x] registers. Avoid operation with non-listed values.
14.2.15. Registers PRT_CNT_ON[0:3]
Each bit field [9:0] of these registers holds the maximum turn-on time for light outputs LD1, LD2, LD3
and LD4.

PRT_CNT_ON0 : maximum turn-on time for light output LD1

PRT_CNT_ON1 : maximum turn-on time for light output LD2

PRT_CNT_ON2 : maximum turn-on time for light output LD3

PRT_CNT_ON3 : maximum turn-on time for light output LD4