opto engineering AO series, Инструкция по эксплуатации

Страница: 33 / 46

AO SERIES | INSTRUCTIONS MANUAL
33
TYPE
Serial
String
Command Description Example
Example
explanation
CONFIGURATION
30 +
Focus (%)
SET OUPUT
FOCUS PERCENT Set the focusing power
of the adaptive lens
30 70
Set the output percent
focus equal to 70%
CONFIGURATION 31
GET FOCUS
POWER Get the focusing power
of the adaptive lens
CONFIGURATION
32 +
po
Focus (%)
SET FOCUS
AT POSITION X
Load the percent focus
value into the specified
position of the loop.
32 2 75
Set the focusing power
of the 2
nd
position
of the loop equal to 75%
CONFIGURATION 33
GET FOCUS
AT POSITION X
Get the percent focus value
from the specified position
of the loop.
33 3
Get the focusing power
of the 3
rd
position
of the loop
CONFIGURATION
34 +
position
RESET
VOLTAGE LOOP
AT POSITION X Reset the focusing percent
value of the specified
position of the loop.
34 2
Reset the focusing
power for the 2
nd
position
of the loop
CONFIGURATION
35 + loop
period
[ms]
SET LOOP
REST TIME
Set the time period of the
automatic loop procedure.
Valid values range between
10 ms and 10 s.
35 100
Set the loop rest time
equal to 100 ms
CONFIGURATION 36
GET LOOP
REST TIME Get the time period of the
automatic loop procedure.
36
CONFIGURATION
37 +
trigger
time [ms]
SET TRIGGER
ON-TIME
DURATION
Set the time duration of the
output trigger signal
37 10
Set the output trigger
duration equal to 10 ms
CONFIGURATION 38
GET TRIGGER
ON-TIME
DURATION
Get the time duration of the
output trigger signal
The acceptable values which can be set for the different parameters are listed in the
table below:
Parameter min max Unit
Percent value for automatic loop procedure 0 100 %
Test loop positions 1 5 -
Time loop period (T
LOOP
) 10 10000 ms
Time duration of the trigger signal 1 500 ms