opto engineering AO series, Инструкция по эксплуатации

Страница: 10 / 46

AO SERIES | INSTRUCTIONS MANUAL
10
Connector Pinout CBGPIO001 WIRE COLOR ** Signal
1 Blue GND (-)
2 Red 24V (+)
3 Pink NC
4 Grey A/D_IN_0
5 Yellow NC
6 Green DIG_OUT -
7 Brown COMMON (Dig_IN)
8 White RS232_RX*
9 Black RS232_TX*
10 Light Blue D
11 Orange A/D_IN_1
12 Violet NC
Shield (no color) PE
Table 1: Hirose 12-pin connector pinout (top view of male connector present on the AOL0223X).
* RS232_RX and RS232_TX refer to the internal electronics.
Connect the “User RS232_TX” and “User RS232_RX” to pin 8 and 9, respectively.
**CBGPIO001 is the part number of the Hirose 12-pin connector cable (with flying leads termination).
The figure above is the representation of the pinout of the male connector present
on the AOL0223X electronic board (top view). The reference for pin 1 can be seen
in Figure 2.
2.3.2 Power supply
Power supply is directly fed through pin 1 and pin 2 of the Hirose 12-pin connector.
Power supply specifications are listed in the following table.
Specification Value
Voltage [V] 24
Power [W] 5
2.3.3 Ethernet
Ethernet communication is used for data transmission between the PC and AOL0223X,
using TCP/IP protocol. Connect AOL0223X directly to the PC using a standard Ethernet
cable.
The default parameters for starting the communication with the AOL0223X are listed in
the following table:
Parameter Default Value
IP Address (Static) 192.168.1.200
Subnet Mask 255.255.255.0