objectives)
40X
100X
7
60X/0.85 achromatic objective
8
LED transmitted illumination
9
Siedentopf trinocular inclined at 30
º
(360
º
rotatable)
4. Assemblage
Please read the safety notice carefully before assembly and make the assembly according to the following
steps.
Tools: wrench (2 pcs)
4.1 There is correct input voltage in the label on microscope.
Make sure the voltage in your position is right. Improper input
voltage may cause short circuit and fire. The microscope will
be damaged.
Turn off the power supply (turn the switch to “O”) and insert
one end of the electronic cord (connector) into the entrance for
AC. Insert the other end of the electronic cord (pin) into the
grounded AC connector and make sure that the electronic cord
has been connected safely
﹡
Please use the supplied electronic cord by manufacturer
﹡
Please make sure to use PE electronic cord when using extra-long electronic cord.
﹡
Pay attention that the microscope should be placed near AC connector and the AC connector is
touchable for users
4.2 The clamps fix the stage and focusing adjustment firmly
during transportation.
Handle the grooves beside collector and pull it out. Remove
the clamps by wrenches.
﹡
Mechanical stage
There is one clamp fixing the mechanical stage in Y axis
direction. Remove the bolts and clamps.
﹡
Focusing adjustment
Pull out the collector. The bracket is fixed by one clamp.
Please remove the bolts and clamps.
4.3 Mount the binocular head
Loosen the fixing screw in the eye tubes and insert the
binocular head into the eye tubes. Then tighten the screw.
