Optimum 3338460, Руководство по эксплуатации

Страница: 96 / 148

Version 1.1.8 - 2021-7-29 96 Translation of original instructions
MB4P ǀ MB4PV EN
MB4P_
M
B4PV
_GB
_4.
fm
4.12 Drill-Mill head
4.12.1 Height adjustment
The height can be adjusted by hand crank or via the motor for height adjustment.
ATTENTION!
Damage to the engine and/or other components. The height adjustment is not designed
for drilling or milling.
4.12.2 Drill depth stop
Use the drilling depth stop (25) when drilling several holes of the same depth.
Img.4-7: “Threading“ on page 99
4.12.3 Automatic spindle sleeve feed
ATTENTION!
The higher the preset number of revolutions, the greater the feed speed in the sleeve.
Make sure to use the correct speeds depending on the used material and on the drill
diameter.
Img.4-4: milling head for automatic quill feed
INFORMATION
The maximum path of the drill depth stop is a full revolution of the scale ring (33).

Set the feed rate (28).

Activate the automatic spindle sleeve feed (26).

Loosen the clamping lever (32) of the sleeve.

Set the drill depth stop with scale ring (33) and the clamping lever (30).

Loosen the knurled screw for the prevention of automatic quill feed.

Drag the spindle sleeve lever (29) to right.
26 Automatic spindle sleeve feed selector
27 Clamping lever drill-mill head
28
Selector switch for speed of feed

0.1 mm/rev

0.18 mm/rev

0.26 mm/rev
29 Spindle sleeve lever
30 Clamping lever scale ring
31 Knurled screw for automatic quill feed prevention
32 Clamping lever for sleeve
33 Scale ring drill depth
28
26 27
29
30
31
32
33