EYDFA-33-PM-R Operation Manual
R1.00
Page 2 of 15
Optilab, LLC
600 E. Camelback Road, Phoenix, AZ 85012
Phone: 1-877-303-3888, Fax: (602) 343-1489, Email: [email protected]
In case when catastrophic failure (plasma formation) has occurred, DO NOT
enable the lasers again. Otherwise the optical fiber will continue to burn
towards the source of laser radiation at about 1m/s.
Plasma Formation (fiber on the left)
OPTICAL COMPONENTS CONNECTED TO THE OPTICAL OUTPUT MUST BE
RATED FOR HIGH POWER USE
. It is highly recommended that these components
be properly cooled to dissipate heat.
FOR CONTINUED PROTECTION AGAINST FIRE, REPLACE ONLY WITH SAME
TYPE AND RATING OF FUSE.
The equipment is certified for EMC requirements.
THE USER SHOULD NEVER
OPEN THE EQUIPMENT CASE
; any attempt will void the warrantee and may result
in electric shock and EMI attack to equipment in the vicinity.
Avoid using any solvent or vaporizing chemical to clean the equipment panel or case.
It may result in damage to the surface and internal circuits.
