EYDFA-33-PM-R Operation Manual
R1.00
Page 7 of 15
Optilab, LLC
600 E. Camelback Road, Phoenix, AZ 85012
Phone: 1-877-303-3888, Fax: (602) 343-1489, Email: [email protected]
Feature
Function
AC Power Socket
The AC power socket is the input for the AC power source.
A three-pin standard power cord should be used to connect
this equipment to any 110 or 220 V main supply.
Main AC Power
Switch
This switch enables the electrical power to the DFB-B unit.
USB Female Socket Using a USB cable, this port allows for remote control and
monitoring through a PC workstation.
Ventilation Fans
The ventilation fans ensure proper ventilation inside the
unit. The back panel and the two sides of this equipment
should be placed at least 3 inches from the wall to dissipate
heat effectively.
Interlock
This BNC female connector is a safety interlock. It must be
shorted in order for the pump lasers to enable. Use the
provided accessory to short this port or connect it to a
compatible interlock device. If the interlock is open during
normal operation, the pump lasers will be turned off. To re-
enable the pump laser output, turn the output switch on the
front panel to “OFF” position first and start over.
1
2
Rear Panel
4
3
5
4
