EYDFA-33-PM-R Operation Manual
R1.00
Page 9 of 15
Optilab, LLC
600 E. Camelback Road, Phoenix, AZ 85012
Phone: 1-877-303-3888, Fax: (602) 343-1489, Email: [email protected]
3.2.3
Change Front Panel Setting
To toggle between operation modes or to adjust digits of the pump currents, us the shift key
to highlight a parameter to change (it will turn yellow). When the parameter is highlighted,
use the “INC” button to cycle through the options. For the pump current, adjust each digit,
then press “SAVE” to engage the newest settings. The newest current setting value will not
be displayed until the key switch is turned to ON position. The maximum currents of each
diode are displayed but cannot be altered. The Input / output power read by the internal PD
is also displayed.
The “ESC” button will deselect your selection.
