Optical Systems Design OSD2700SFP SERIES, Руководство оператора

Страница: 170 / 223

OPTICAL SYSTEMS DESIGN
DOC ID: 10112704
OSD2700SFP OPERATOR MANUAL
PAGE 170
The following example enables the timeout mechanism for the port to be enabled back for bridge
GROUP (
1
):
switch_a(config)#bridge 1 spanning-tree errdisable-timeout enable
switch_a(config)#
Interval:
1.
Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode).
The
switch_a(config)# prompt will show on the screen.
switch_a(config)#
2.
Usage:
Use this command to specify the time interval after which a port is brought back up. The range of
interval value is from 10 to 1000000. And the default value is 300 seconds.
3.
Command Syntax:
bridge GROUP spanning-tree errdisable-timeout interval <10-1000000>
no bridge GROUP spanning-tree errdisable-timeout interval
GROUP <1-1> Bridge-group ID used for bridging.
<10-1000000> The error disable timeout interval in seconds.
4.
Example:
The following example sets error disable timeout interval time 100 seconds for bridge GROUP ( 1 ):
switch_a(config)#bridge 1 spanning-tree errdisable-timeout interval 100
switch_a(config)#
Advanced Per Port Configuration:
Portfast configuration / status:
1.
Command Mode: Interface mode
Logon to Configure Mode (Configure Terminal Mode).
Then logon to Interface mode.
fe1 means port 1.
The
switch_a(config-if)#
prompt will show on the screen.
switch_a(config)#interface fe1
switch_a(config-if)#
2.
Usage:
Use this command to set a port as an edge-port and to enable rapid transitions.
Use the no parameter with this command to set a port to its default state (not an edge-port) and to
disable rapid transitions.
3.
Command Syntax:
spanning-tree portfast
no spanning-tree portfast
4.
Example:
The following example sets the interface fe1 (port 1) as an edge-port and to enable rapid transitions:
switch_a(config)#interface fe1
switch_a(config-if)# spanning-tree portfast
switch_a(config-if)#