Optical Systems Design OSD2700SFP SERIES, Руководство оператора

Страница: 125 / 223

OPTICAL SYSTEMS DESIGN
DOC ID: 10112704
OSD2700SFP OPERATOR MANUAL
PAGE 125
Restore Default:
1.
Command Mode: Privileged Exec mode
Logon to Privileged Exec Mode (Enable Mode).
The
switch_a# prompt will show on the screen.
switch_a#
2.
Usage:
Use
restore default
command to restore default setting of the switch.
3.
Command Syntax:
restore default
4.
Example:
The following example restores default setting of the switch:
switch_a#restore default
switch_a#
Auto Save:
1.
Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode).
The
switch_a(config)# prompt will show on the screen.
switch_a(config)#
2.
Usage:
Use this command to enable auto save configuration function. The configuration will be automatically
saved at every configured interval while this command is enabled. Use the no form of this command to
disable this feature.
3.
Command Syntax:
service auto-config enable
no service auto-config enable
4.
Example:
The following example enables or disables auto save configuration to switch:
switch_a(config)#service auto-config enable
switch_a(config)#no service auto-config enable
switch_a(config)#
Auto Save Interval (5~65536 sec):
1.
Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode).
The
switch_a(config)# prompt will show on the screen.
switch_a(config)#
2.
Usage:
Use this command to set the interval when the configuration would be automatically saved. The range
of interval value is from 5 to 65535. And the default value is 30 seconds.
3.
Command Syntax:
service auto-config interval WORD
WORD specifies the interval value.