Optical Systems Design OSD2700SFP SERIES, Руководство оператора

Страница: 124 / 223

OPTICAL SYSTEMS DESIGN
DOC ID: 10112704
OSD2700SFP OPERATOR MANUAL
PAGE 124
3.
Command Syntax:
install image IP-ADDRESS WORD
IP-ADDRESS specifies the IP address of tftp server.
WORD specifies the file name to be loaded to switch.
4.
Example:
The following example specifies upgrading firmware (file name: flash.tgz ) from tftp server (IP
address: 192.168.1.100) to switch:
switch_a#install image 192.168.1.100 flash.tgz
switch_a#
LOAD CONFIG TO TFTP SERVER:
1. Command Mode: Privileged Exec mode
Logon to Privileged Exec Mode (Enable Mode).
The
switch_a# prompt will show on the screen.
switch_a#
2.
Usage:
Use write config-file command to backup configuration file to tftp server.
3.
Command Syntax:
write config-file IP-ADDRESS
IP-ADDRESS specifies the IP address of tftp server.
4.
Example:
The following example backups configuration file to tftp server (IP address: 192.168.1.20) :
switch_a#write config-file 192.168.1.20
switch_a#
SAVE CONFIGURATION:
1. Command Mode: Privileged Exec mode
Logon to Privileged Exec Mode (Enable Mode).
The
switch_a#
prompt will show on the screen.
switch_a#
2.
Usage:
Use copy running-config startup-config command to write configurations to the file to be used at
startup. This is the same as the write memory command.
3.
Command Syntax:
copy running-config startup-config
4.
Example:
The following example specifies writing configurations to the file to be used at startup to switch:
switch_a#copy running-config startup-config
switch_a#