Opex Eagle Remittance Processor, Руководство оператора

Страница: 102 / 108

102
Eagle Operator Manual
OPEX Corporation
B.3. Rejects
Reason Description
No Singulation
The singulator exit sensor detected no gap or a
very small gap between the pieces in a pair.
Too Little Singulation
The lead edge to lead edge pitch between pieces
in a pair was measured at the MICR entry sensor
and was smaller than the MINIMUM GOOD
SINGULATION PITCH machine parameter.
Too Much Singulation
The lead edge to lead edge pitch between pieces
in a pair was measured at the MICR entry sensor
and was greater than the MAXIMUM GOOD
SINGULATION PITCH machine parameter.
Invalid Content MICR
Report
The content MICR sent no report or more than one
report for a pair to the main control board.
Unknown MICR Profile
The content MICR could not recognize the profile
of the magnetic ink on the check in a pair.
MICR Found Two
Statements
The content MICR found no MICR ink on either of
the pieces in a pair.
MICR Found Two
Checks
The content MICR found valid MICR ink profiles on
both pieces in a pair.
Out Of Order
With windowed mail, the content MICR detected
that the check and the document in a pair were out
of order.
Cannot Orient
Document
With windowless mail, the content OCS was not
able to determine the orientation of the document
in a pair.
Reverser Bypassed
The machine control system determined that the
gap between pieces in a pair was too small to allow
the reverser to operate properly. (This should only
occur when two pieces in a row must be reversed.)
Jamsorts
Accounts for pieces that were directed into the
reject bin during a jam condition.