Onwa KV-290, Руководство по установке

Страница: 6 / 39

Installation of Connecting Cables
DC Power Connector (1-Black, 2-Red)
Fuse Replacement
Ground Terminal (3- Screw Hole)
NMEA In/Out Lead
Connect a PC or navigation equipment (4-White):
Connect a GPS receiver (5-Red):
Clone Lead (6-Blue)
3
Antenna
4
5
6
7
1
2
3
When connecting the external speaker, GPS, DC power supply,
computer and navigation device by the rear panel cable end, cover the
connectors and cables with rubber vulcanzing tape as below, to
prevent water seeping into the transceiver.
Red - Po), Black - Negative(-).The output voltage of the
connected DC power supply must be 13.8V. Do not connect the
transceiver to the 24V storage battery. If the current supplied to the
transceiver is insufficient, the display may darken during transmission
or the transmitting output power may drop significantly.
One fuse is installed in the supplied DC power cable. If a fuse blows
or the transceiver stops functioning, track down the source of the
problem first, then replace the damaged fuse with a new, rated one.
Notice: Please power off transceiver before replacing the fuse, the
required fuse is DC15A.
Connect this terminal to a vessel ground to prevent electrical shocks
and interference from other equipment occurring. Use a PH M3×6
mm screw (not supplied).
Through the rear panel cable, this transceiver can connect GPS input
signals from GPS receivers, and can also output GPS signals to
other devices.
Used to output position data received from other ships to a
computer or navigation device.
Transceiver output signal conforms to NMEA0183 version 3.01
sentence formatters DSC, DSE compatible .
Used for ship position indication.
A NMEA0183 ver. 2.0 or 3.01 (sentence formatters RMC, GGA,
GNS, GLL) compatible GPS receiver is required.
Connect a cloning cable.
VulcanzingTape