Onkyo TX-RZ3100, Руководство пользователя

Страница: 41 / 159

Initial Setup
When you turn the unit on for the first time after purchasing it, Initial Setup is
automatically shown on the TV to enable you to make settings required for startup
using simple operations following onscreen guidance.
Operation:
Select the item with the cursors of the remote controller and press ENTER to
confirm your selection. To return to the previous screen, press .
To redo Initial Setup:
If you terminate the procedure on the way or want to change a setting made
during Initial Setup, press on the remote controller, select "7. Miscellaneous" ­
"Initial Setup", and press ENTER.
1. AccuEQ Room Calibration
Place the supplied speaker setup microphone in the listening position, measure
the test tones emitted by the speakers, then the unit automatically sets the
optimum volume level for each speaker, the crossover frequencies, and the
distance from the listening position. This also reduces the influence of standing
waves to suit the listening environment, automatically adjusts the equalizers for
the speakers, and enables correction of distortion caused by the acoustic
environment of the room.
Calibration takes between 3 to 12 minutes to be completed. The speakers emit
the test tone at high volume during measurement, so be careful of your
surroundings. Keep the room as quiet as possible during measurement.
When using THX certified speakers, THX recommends setting the crossover
frequency to "80Hz(THX)". It is also recommended to manually adjust the
settings for each speaker to suit the specific characteristics of each room.
If the power of this unit suddenly turns off, the wires in the speaker cables may
have touch the rear panel or other wires and tripped the protection circuit. Twist
the wires again properly and make sure they do not stick out of the speaker
terminals when connecting.
Settings