5
Important Safety Instructions
To reduce the risk of fire, electric shock or injury:
Read all instructions before using this floor machine.
1)
DO NOT
leave the floor machine plugged in when not in use. Unplug from the outlet when not
in use and/or before servicing.
2)
Electric shock could occur if exposed to rain. Store indoors.
3)
This is NOT a toy. Close attention is necessary when used around or near children.
4)
Use only as described in this manual. Use only manufacturer's recommended attachments.
5)
DO NOT
use with damaged cord plug. If the floor machine is not working as it should because it
has been dropped, damaged, left outdoors, or dropped into water, contact the manufacturer or
authorized service center.
6)
DO NOT
handle the plug or operate with wet hands.
7)
DO NOT
pull or carry by cord, use power cord as a handle, close a door on cord, or pull cord
around sharp edges or corners. DO NOT run floor machine over the cord. Keep cord away from
heated surfaces.
8)
DO NOT
unplug by pulling on cord. To un- plug, grasp plug, not the power cord.
9)
DO NOT
put any object into motor openings.
10)
Keep hair, loose clothing, fingers and all parts of body away from moving parts.
11)
DO NOT
use a vacuum without the proper manufacturer’s filters in place.
12)
DO NOT
operate where anesthetics and oxygen are used.
13)
DO NOT
use around flammable or combustible liquids such as gasoline or use in areas
where they may be present.
14)
Replace damaged or worn parts immediately with genuine Onfloor equipment parts to maintain
safety and protect your limited warranty.
15)
Floor sanding can result in an explosive mixture of fine dust and air. Use a floor sanding
machine only in a well-ventilated area.
16)
This floor machine must be connected to a properly grounded outlet only. (See grounding
method on page 6)
