8
Installation & Changing of Accessory Tools
When installing or changing tools, turn OFF the
Machine and disconnect the power cord from the electrical outlet
Before Installation or Changing Attachments:
1. Unplug the machine from the wall outlet.
2. Ensure handle is in the storage position (straight up) and locked in place with the quick release pin.
3. Tilt machine back by bracing it with your foot until the handle is lying on the floor and the three
heads are fully exposed.
Note
: It is recommended that a towel or pad is placed under the machine to
protect the floor.
Changing and Installation of Attachments
Always wear protective gloves when installing or removing attachments,
1. Position the first attachment head at 12 o’clock.
2. Using one hand as leverage and the other to reach beneath the bottom side of the attachment and
pull up towards yourself to free it from the mounting pins. Turn the attachment 180 degrees and pull up
again and the attachment will be freed.
3. Select the attachment required for the job, line up the holes on the attachment with the four metal
pins protruding from each of the three heads.
4. Push attachments on by hand and if necessary, carefully tap it into place with a rubber mallet.
5. Repeat steps 1 thru 4 with the remaining 2 attachments.
6. Carefully raise the handle, supporting the axle with your foot to control the head of the machine as it
is placed on the floor.
7. Since the attachments are different heights, you may need to adjust the dust skirt to make sure it is
level with the attachments. This will ensure clean and virtually dust-free operation.
8. To adjust skirt, align the skirt with the center of the machine and wrap it around allowing bottom
edge of skirt to contact floor.
9. Move the handle back to the operating position and lock in place with the quick release pin.
