7
Operating Instructions
1)
Clear the floor of any materials or objects.
2)
Select and install the accessory tools required for the job. (See p 8 for installation instructions.)
3)
Move the handle from the upright “storage” position to the angled “operating” position and lock in
place with the quick release pin.
4)
Place your hands on the handle grips and apply slight pressure to lighten the load on the tools.
DO
NOT
lift the tools off of the ground!
5)
Push the start switch toggle forward to “ON” position. Motor will start.
6)
When the machine is running, remove handle pressure and lower completely onto the working
surface.
7)
To stop the machine push, start switch toggle backward to “OFF” position.
Note: If machine unexpectedly shuts down due to a circuit overload, check to see if the on-board circuit
breaker has opened. This is located on the handle beneath the handle grips. If the button is extended
out, wait 1 minute before pushing in to reset. If the breaker will not reset, wait several minutes before
attempting to reset again. If on-board breaker has not opened, check breaker box feeding the outlet
that the machine is plugged into. TURN MACHINE TOGGLE TO “OFF” POSITION BEFORE RESETTING
CIRCUIT BREAKER.
DO NOT attempt to operate this unit if the machine is not fully assembled. When
servicing or replacing accessories turn OFF the machine and disconnect from the
power source.
[This section intentionally left blank]
