One World Touch MP1200, Руководство по обслуживанию

Страница: 21 / 110

Service Manual version 1008
MP1200/MP1500 (PC920 Intel 945G)
2-13
2.6. Running the BIOS Setup
If you are a commercial user, the MP1200/MP1500 system should have been properly set up and
configured by your dealer. You may still find it necessary to change the system configuration
information. In this case, you need to run the system’s BIOS setup program.
Under the following conditions, the CMOS settings are to be changed.
1. The system is starting for the first time.
2. The hardware devices attached to the MP1200/MP1500 system have been changed.
3. The CMOS memory has lost power and the configuration information has been erased.
The BIOS setup program is stored in ROM, which can be accessed by pressing <DEL> key on the
keyboard immediately when the system is powered on.
In order to retain the specified setup information when the system power is turned off, the system
setup information is stored in a battery-backed CMOS RAM. The battery is to ensure the settings will
not be erased when the computer is turned off or reset. When the computer is powered on again, the
system will read the settings stored in the CMOS RAM and compare them to the equipment check
conducted during the power on self-test (POST). If any error or mismatch occurs, an error message
will be shown on the screen and the computer will be prompted to run the setup program.
To change the BIOS setup, please refer to Chapter 7 for more information.
2.7. Operating System and Driver Installation
The MP1200/MP1500 system is not equipped with an operating system when delivered from the
original manufacturer. If you are a commercial user, the system is likely to have been pre-installed
proper operating system and software drivers by your dealer or system integrator.
If the system is not pre-installed with any system OS and drivers or you intend to install your
preferred ones, there are several ways to load OS and software into the system.
1. Via an USB data-retrieval devices
2. Via the CD-ROM
3. Via Ethernet
Recent releases of operating systems always include setup programs that load automatically and
guide you through the installation. You can also refer to your OS user manual for instructions on
formatting or partitioning the hard disk drive before any software installation.
The MP1200/MP1500 system provides the following utility drivers stored in the CD-ROM diskette or
utilities diskettes;

Ethernet utilities

VGA utilities

Audio drivers

Touchscreen drivers