301 Fulling Mill Road, Suite G ©Copyright 2004 by OnQ Technologies,
Middletown, PA 17057
Inc All Rights Reserved.
(800)-321-2343
www.onqhome.com
Innovations in Home Living.
on the OnQ 4-Port 10/100 Router/Switch.
7.
An additional CAT5e patch cable is then connected from the
network (WAN) port of the 4 Port 10/100 Router/Switch to
the Cable Modem or DSL Modem housed in the structured
wiring enclosure.
8.
The 4 Port 10/100 Router/Switch is powered with an AC to
DC adapter which also needs to be plugged in to an AC source.
9.
Follow the steps in the next two sections for configuring the
router.
NOTE: Use proper tools and standard TIA 568A rules to prep and
terminate the CAT5e cable, such as the On-Q Home CAT5 Cable
Stripper (P/N 363292-01) and the On-Q Home EZ RJ45 Crimp Tool
(P/N 364555-01).
8
301 Fulling Mill Road, Suite G ©Copyright 2004 by OnQ Technologies,
Middletown, PA 17057
Inc All Rights Reserved.
(800)-321-2343
www.onqhome.com
Innovations in Home Living.
D. Local Port Setup
This screen (see
Figure 9
) contains settings for configuring the LAN
(4-port switch) side of the product, where your PCs are connected.
You can set to distribute IP address to local PCs or not. If
“Distribute IP address to local computer” is selected, users can enter
the starting IP address for the group of attached PCs. The number of
IP address decides the total number of clients allowed.
NOTE: All the PCs on the same LAN (switch) should use the same
subnet Mask.
Users can also set Static DHCP in this page. Users are allowed to set
32 Static DHCP. Using this feature, the device will assign the same
IP address to a computer (according to the network adapter’s MAC
address) and this computer becomes the only one able to request that
IP address. This is useful for support of virtual servers which require
fixed IP addresses for outside Internet access.
Private Network
IP Address
Default: 192.168.1.254 (this is the local
address of this On-Q Router/Switch)
Subnet mask
Default: 255.255.255.0
Figure 9
17
