OMS KEA 300 TGI, Руководство по эксплуатации и обслуживанию

Страница: 17 / 36

17
CHAPTER 4 INSTALLATION
4.1 POSITIONING THE MACHINE
The surface on which the slicing machine must be installed must take into
account the support dimensions shown in the technical tables (depending
on the model), and therefore be sufficiently large, should be well levelled,
dry, smooth, robust and stable and at a height of 80 cm from the ground.
4.2 ELECTRICAL CONNECTION
4.2.1 SLICING MACHINE WITH SINGLE PHASE MOTOR
The slicing machine is equipped with a power cable with a cross section of
3x1 mm
2
, length of 1.5 m and a “SCHUKO” plug (or specific plug for the
country of destination) to be connected to an outlet in line with EEC
standards. Connect the 230 Volt 50 Hz slicing machine, interposing a 10A,
I
 n = 0.03 A RCD/circuit breaker.
At this point, ensure that the earthing system is in perfect working order.
Also check that the type of current indicated on the identification plate
(Fig. 5) is consistent with the voltage (V) and frequency (Hz) of the
power line.
Figure 5 - Data plate - Serial number
4.2.2 SLICING MACHINE WITH THREE PHASE MOTOR
The slicing machine is equipped with a power cable with a cross section of
5 x 1 mm
2
and length of 1.5 m.
Connect the slicing machines to the 400 Volt 50 Hz three phase mains
using a CEI plug (red), interposing a 10A, I
 n = 0.03 A RCD/circuit
breaker. At this point, ensure that the earthing system is in perfect
working order. Also check that the type of current indicated on the
identification plate (Fig. 5) is consistent with the voltage (V) and
frequency (Hz) of the power line. Before connecting the machine
permanently to the three phase supply line, check the direction of
rotation of the blade by briefly pressing the start blade button then
pressing the stop blade button (Fig. 8).