Omron NT11S, Руководство по эксплуатации

Страница: 60 / 183

44
Operation Modes and the System Menu
Section 3-3
3-3 Operation Modes and the System Menu
The NT11S operates in either “RUN”, “Transmit”, or “Maintenance” mode. The op-
eration modes can be switched by using the System Menu.
3-3-1 System Menu and the Operation Modes
Select an operation mode by locating the cursor on the required item with the [
"
] [
#
]
keys, then press [Enter] to confirm the selection. The operation modes with re-
spect to the System Menu are related to each other as shown below.
For the operations with the System Menu, refer to the “Operations with the System
Menu” (page 46).
SYSTEM MENU
Quit
Transmit Mode
Maintenance Mode
Have system
settings and screen
data registration
been completed?
To change
system settings
or screen data
contents
System
program
installed/
not installed
Not installed
Installed
ENTER
Have two
function keys
been pressed?
System Transfer Mode
This is the mode in
which the system
program is transferred
form the system transfer
tool to the NT11S.
The NT11S runs in this
state. Controls from the
PC are enabled and
various indications and
I/O operations are made.
RUN mode
System Program
isn’t installed.
Press ENTER key
to start install
No
Yes
No
Yes
Transmit Mode
Screen data and other
data are transmitted
between the NT11S and
a support tool.
Maintenance Mode
The NT11S
maintenance operations
such as memory
initialize and setting
check are executed.
Power
ON