27
Vibration & temperature monitoring type (K6CM-VB)
Dedicated tool
EtherNet/IP
Object monitored
K6CM-VBS1
(pre-amplifier)
K6CM-VB
1 m
(extendable to 100 m)
2.6 m
Single-phase
power supply
Output signal
(transistor output)
Measurement
trigger signal
LAN
Sensor head
Connector
Tighten screw
perpendicularly
directly above
rotation shaft
(load side)
0.3 m
Inverter *1 (measurement is also possible without an inverter)
Three-phase
power supply
(pre-wired cable)
(pre-wired cable)
By keeping a PC or PLC continuously connected, you can monitor the state of a motor.
Modbus TCP
*2
Built-in EtherNet/IP port
Note.
Even without a PC, the alarm bar of the main unit notifies you of changes of motor state.
*1. When you use an inverter to drive the motor, you may not be able to check the degradation tendency of the motor.
In the conditions below, acceleration fluctuations tend to occur more frequently.
• The frequency is stable at an inverter drive frequency of 50 Hz or higher.
• The inverter carrier frequency is stable at 12.5 KHz or higher.
Test in the actual installation environment before use.
*2.
Can be used only with EIP CPU version 1.2 or higher.
