Omron HBF-206IT, Инструкция по эксплуатации

Страница: 34 / 44

34
TRANSFERRING THE DATA
3. Press the UPLOAD button.
The display changes to the data transmission screen, and the unit starts
transferring the data.
If the data is sent successfully, the OK indicator lights and the alarm
will beep (Blip! Blip!).
NOTES:
• If you press the UPLOAD button while the data is being
transferred, the transfer will be stopped and the display will revert
to the previous screen.
• If the data transmission fails, then the Err indicator lights and the
alarm will beep three times (Beep! Beep! Beep!). Check the
application on the connected device, then repeat the procedure from
step 2 to try again.
4. Press the WEIGHT/OFF button to turn the monitor off.
NOTE: If you forget to turn the monitor off, the screen will return to the screen displayed before
data transmission started after 10 seconds.
About Data FULL Indicator
Up to 30 sets of measurement results can be stored for each personal
profile number.
If the number exceeds 30, the oldest results are deleted.
If the Data FULL indicator blinks or remains lit, transfer data to a device
as soon as possible to avoid losing measurement results.
blinks: 24-29 sets of measurement results have been stored.
lit:
30 sets of measurement results have been stored.
NOTE: The Data FULL indicator is not displayed when only 0 to 23 measurements results are stored.
DATA FULL
Indicator
HBF-206IT-Z_B_M.fm Page 34 Monday, February 22, 2010 4:24 PM