Omron FB LIBRARY -, Руководство для стартапов

Страница: 68 / 162

2-6. Inverter setting
For performing DeviceNet Communication, the following parameters have to be set.
* The parameters shown here is incorporated into DeviceNet communication Unit when power is
turned ON.
For this reason, change of parameter must be made after turning OFF the source power.
2-6-1. 3G3M series Inverter Parameter Setting
Frequency command from option
(DeviceNet Communication Unit) is enabled
0 9
Frequency command
selection
n004
0
0
Factory
setting
Unit: Hz 0
Unit selection at
frequency command
selection/reference
n035
Input from option (DeviceNet
Communication Unit) is enabled
3
Operation command
selection
n003
Description
Setup
figure
Name
Parameter
constant No.
Concerning other parameters set depending upon operation conditions.
Concerning change and detail of parameter, check the following manuals.
I527-E1 3-1 Operation of Digital Operator
I539-E1 4-1 SYSDRIVE 3G3MV Series Set-up
2-6-2. 3G3RV series Inverter Parameter Setting
Description
Factory
setting
Setup
figure
Name
Parameter
constant No.
Free run stop/error detection 1 1
Operation selection at
communication error
F6-01
Detect always 0 0
Detection method selection
at communication outer
error input
F6-02
Free run stop/error detection 1 1
Operation selection at
communication outer error
input
F6-03
Operation command by Option Card
(DeviceNet communication card)
1 3
Operation command
selection
b1-02
0
1
Unit: Hz 0
Unit selection at frequency
command
selection/reference
o1-03
Frequency command by Option Card
(DeviceNet communication card)
3
Frequency command
setting
b1-01
Concerning other parameters set depending upon operation conditions.
Concerning change and detail of parameter, check the following manuals.
I532-E1 3-2 Digital Operator
I539-E1 4-2 SYSDRIVE 3G3RV Series Set-up
2-6 Inverter
3G3MV-A2
†††
/-AB
†††
/-A4
†††
3G3RV-A2
†††
/-A4
†††