CHAPTER 5 PARAMETERS
E5EK
5--38
•
The parameters in this mode can be used only when the “security” parameter
(protect mode) is set to “0” and “1”.
•
This mode contains the parameters for setting expanded functions. These parame-
ters include parameters for setting the SP setting limitter, selecting advanced PID
and ON/OFF control, and setting the program time unit, step time/rate of rise
programming, time unit of ramp rate and the automatic return of display mode.
•
To select this mode, press the
key for 1 second minimum. The display changes
to the menu display. If you select [
] using the
and
keys, and then
press the
key for 1 second minimum, the controller enters the expansion
mode.
•
To select parameters in this mode, press the
key. To change parameter set-
tings, use the
or
keys.
•
The following table shows the parameters supported in this mode and the page
where the parameter is described.
Symbol
Parameter Name
Page
Set point upper limit
5-39
Set point lower limit
5-39
PID/ON/OFF
5-39
Operation at power ON
5-40
End condition
5-40
Program time unit
5-41
Step time/Rate of rise programming
5-41
Time unit of ramp rate
5-42
PV start
5-42
Wait width
5-43
Alarm during ramp step enable
5-43
Run all enable
5-43
α
5-44
AT calculated gain
5-44
Automatic return of display mode
5-45
AT hysteresis
5-45
LBA detection width
5-45
Expansion Mode
Содержание E5EK
