![background image](http://html1.mh-extra.com/html/omron/c200hw-cort21-v1/c200hw-cort21-v1_operation-manual_742282050.webp)
Physical layout of the Unit
Section 3-1
33
3-1-3 Rotary Switch
The rotary switch is used to set the Special I/O Unit number (or so called
“Machine No.”).
Memory allocation
The Machine number setting determines which words in the Internal Relay
and Data Memory Areas are allocated to C200HW-CORT21-V1.
The valid Unit number setting range depends on the host PLC's CPU Unit, as
shown in the following table.
Any Machine No. in the setting range is allowed as long as it has not been
set on another Special I/O Unit connected to the host PLC. If the same
Machine number is used for the C200HW-CORT21-V1 and another Special
I/O Unit, an "I/O Unit Over" error will occur in the PLC and it will not be
possible to start up the network communication.
Note
Always turn OFF the power to the PLC before changing the Machine number
setting. The Unit only reads the Machine number setting during the
initialisation after power-up, i.e. it is not processed at a software reset.
Use a small flat-blade screwdriver to turn the rotary switch; be careful not to
damage the switch.
3-1-4 Baud rate switches
The DIP switches on the front of the Unit set the CAN communication baud
rate.
Only the first 3 switches are used (BR0, BR1, BR2); the fourth switch (RSV)
is reserved for future use and should remain in the OFF position. The
following table lists all possible DIP switch settings and their corresponding
baud rate.
CPU Unit models
Machine no.
setting range
Setting
method
C200HE,
C200HG-CPU3
❏
-E/CPU4
❏
-E,
C200HX-CPU3
❏
-E/CPU4
❏
-E
0 to 9
Single-digit
hexadecimal
C200HG-CPU5
❏
-E/CPU6
❏
-E,
C200HX-CPU5
❏
-E/CPU6
❏
-E,
CS1-series
0 to F
Содержание C200HW-CORT21-V1
