Omnisense Systems ULS-M384S, Руководство пользователя

Страница: 49 / 52

47
Cannot pan/tilt Dirt build-up Check the space between the turret and the
mounting base for any build-up of deposits.
Gently flush the turret and the mounting base
with fresh water to dislodge the accumulation of
minerals from salt water and sea spray.
No response
from the Joystick
Controller Improper connection Check that the cables are connected properly
and secured into the respective ports.
Check the Joystick Controller’s IP exists inside
the settings page.
If the camera
stops responding Possible strong
external static charge
conflicting IP with other
equipment onboard Switch off the power to the camera. Once the
camera is off, wait a few seconds and then turn
the camera back on.
If the problem persists, conduct Factory Reset
Plug in the power supply to the Junction Box for
15 sec, then remove the power supply from the
Junction Box for 5 secs. Perform this action for a
total of 4 times.
On the 5th time, keep the system power up
and you should be able to operate the camera
system.
Note: The camera turret IP will be reset to the
factory default IP. You may change the IP from
the settings page.
Joystick Controller
not responding
to other
troubleshooting
actions Conflicting IP with other
equipment onboard
Press and hold the and buttons
simultaneously for 10 sec.
The Joystick Controller’s IP will be reset to the
default. To re-connect the Joystick Controller to
the system, you will need to set the camera’s IP
back to the default IP. The equipment should be
connected thereafter.
Junction Box Conflicting IP with other
equipment onboard Press the button - SW10 RST (just beside the
NMEA junction connector) for 10 sec.
The Junction Box’s IP will be reset to the default
IP. To re-connect the Junction Box to the system,
you will need to set the camera‘s IP back to the
default IP. The equipment should be connected
thereafter.
Forget login
password Conduct Factory Reset (See “If the camera stops
responding”)