Omnia Volt, Инструкция по установке и эксплуатации

Страница: 2 / 48

User Warnings and Contact Info
The installation and service instructions in this manual are for use by qualified personnel only.
To avoid electric shock, do not perform any servicing other than that contained in the operating
instructions unless you are qualified to do so. Refer all servicing to qualified personnel
This instrument has an autoranging line voltage input. Ensure the power voltage is within the
specified range of 100-240VAC. The ~ symbol, if used, indicates an alternating current supply.
This symbol, wherever it appears, alerts you to the presence of uninsulated, dangerous
voltage inside the enclosure – voltage which may be sufficient to constitute a risk of
shock.
This symbol, wherever it appears, alerts you to important operating and maintenance
instructions. Read the manual.
CAUTION: HAZARDOUS VOLTAGES
The instrument power supply incorporates an internal fuse. Hazardous voltages may still be
present on some of the primary parts even when the fuse has blown. If fuse replacement is
required, replace fuse only with same type and value for continued protection against fire.
WARNING:
The product’s power cord is the primary disconnect device. The socket outlet should be located
near the device and easily accessible. The unit should not be located such that access to the
power cord is impaired. If the unit is incorporated into an equipment rack, an easily accessible
safety disconnect device should be included in the rack design.
To reduce the risk of electrical shock, do not expose this product to rain or moisture. This unit is
for indoor use only.
This equipment requires the free flow of air for adequate cooling. Do not block the ventilation
openings on the rear and sides of the unit. Failure to allow proper ventilation could damage the
unit or create a fire hazard. Do not place the units on a carpet, bedding, or other materials that
could interfere with any panel ventilation openings.
If the equipment is used in a manner not specified by the manufacturer, the protection provided
by the equipment may be impaired.
II
VOLT MANUAL