To change the chart paper:
1a. Table Mounted Recorder:
To balance the recorder, fully extend the stabilizing arm at the bottom of the
recorder. Refer to Figure 2-8. Continue to Step 2.
Figure 2-8. Stabilizing Arm Fully Extended
1b. Wall Mounted Recorder:
You can also leave the recorder on the wall if it is easily accessible.
2.
Open the door and hold it open with left hand.
3.
Remove the magnetic chart paper knob (Figure 2-9, item #2) and any used
chart paper.
4.
Place the new chart paper (Figure 2-9, item #1) on the spindle and rotate it
until the current time on the chart paper is aligned with the time arrow on the
chart base of the recorder. See Figure 2-9 detail.
5.
When the chart paper is correctly oriented, replace the magnetic knob
(Figure 2-9, item #2), being careful not to alter the position of the chart paper.
6.
Make sure that the “Chart Type” switch, located behind the control panel door,
is in the correct position relative to the chart paper used.
If the switch is in the wrong position, the chart paper will not
rotate at the correct speed causing the chart time not to be
synchronized with the current time.
NOTE
H
U
M
I
D
I
T
Y
RH
°
F
°
C
Setting Up the Recorder
2
2-7
Содержание CT485B-110V-G-AL
