Connect the White wire to the vehicle's Accessory
wire. This circuit supplies power to the Heat, Ventilation and Air Conditioning (HVAC)
system. This wire will show 12 Volts when the ignition key is in the "Run" and "Acces-
sory" positions and No voltage in the "Start" and "Off" positions. The connection point for
this wire is also found in the ignition switch wiring harness.
19
12-Gauge White Wire:
Accessory Output
Connection Required
.
wire is also found in the ignition switch wiring harness (see diagram on previous page).
Some vehicles have a second Starter wire known as a "Cold Start" wire. When this is
encountered, two options are available: program the Yellow/Green wire as a second
starter output, or use an optional relay configured to the 3-pin Red port, to energize the
second Starter wire (see pages 22-23).
Note: If a security system is present which utilizes a starter interrupt circuit, the Green
wire must be connected to the Starter Motor side of the interrupt.
Connect the Yellow wire to the vehicle's Ignition wire
(also known as “Primary Ignition”). This wire will show +12 Volts when the ignition key is
in the "Run" and "Start" positions and no voltage in the "Off" and "Accessory" positions.
This wire is found in the ignition switch wiring harness (see diagram on previous page).
Note: If two Primary Ignition wires are present, use the Yellow/Green wire for the sec-
ond, or configure an optional relay to the 3-pin Red port (see pages 22-23).
12-Gauge Yellow Wire:
Ignition Output
Connection Required
.
22
The Yellow/Green wire is an additional output which
can be programmed to operate as an Ignition output, Accessory output or Starter output.
As received, it is programmed as an Ignition #2 output. This wire
may be used in cases where the vehicle has more than
one of any of these three circuits.
Programming: Locate and open
the small access panel on the top of the
control module case. Place the Jumper
as shown on the pins below the removable
panel on the control module. The factory
setting is the center “Ignition #2” position.
Accessory
Ignition #2
Starter
Jumper
12-Gauge Yellow/Green Wire:
Programmable Output
Connection If Needed
.
Wiring - 3 Wire Connector
This harness, which plugs into the Red 3-pin port on the control module, can be used,
if needed, to configure optional relays to energize additional Ignition or Starter circuits.
Omega OEM security bypass interfaces also use this Red port.
This 22 gauge Blue wire is a 500mA Negative out-
put having basically the same operation as the 12 gauge Blue Ignition output. If two or
22 Gauge Blue Wire:
500mA ( - ) Ignition Output
Connection If Needed.
