Omega CN63100 Series, Руководство пользователя

Страница: 28 / 92

REFERENCE TABLES: CONFIGURATION PARAMETER MODULES
Configure Module 1 - Input Parameters (1-IN) CN63100
Display Parameter
Range and Units
(Factory Setting)
Description/
Comments
tYPE Input Type tc-t - Type T TC
tc-E - Type E TC
tc-J - Type J TC
tc-k - Type K TC
tc-r - Type R TC
tc-S - Type S TC
tc-b - Type B TC
tc-N - Type N TC
LIN - Linear mV display Thermocouple select
r385 - 385 curve RTD
r392 - 392 curve RTD
rLIN - Linear ohms display
(tc-J)
RTD select
SCAL Temperature
Scale °F/°C
(°F) If scale is changed,
be sure to check all
parameters.
dCPt Temperature
Resolution 0 or 0.0
(0) If resolution changed,
be sure to check all
parameters.
FLtr Digital Input
Filtering And
Display
Update 0 to 4
(1) Increase number for
more filtering effect.
4 = 500 msec display
update rate. Adjusted
by Auto-Tune.
Display Parameter
Range and Units
(Factory Setting)
Description/
Comments
SHFt Input Signal
Shift (correction
offset) -999 to 9999
1 or 0.1 degree
(0) Normally set to 0.
SPLO Setpoint Lower
Limit -999 to 9999
0 or 0.1 degree
(0) Set low limit
below high limit.
SPHI Setpoint Upper
Limit -999 to 9999
1 or 0.1 degree
(9999) Set high limit
above low limit.
SPrP Setpoint Ramp
Rate 0.0 to 999.9 degrees/minute
(0.0) 0.0 is off (no
ramping)
InPt User Input * PLOC - Program disable
ILOC - Integral action on/off
trnF - Auto/manual select
SPrP - Setpoint ramp on/off
ALrS - Reset alarm output(s)
SP2 - Select SP1/SP2
rSP - Select
Local/Remote
PrNt - Serial block print
(PLOC)
Low = lock
Low = off
Low = manual
Low = end ramp
Low = reset
Low = SP2
Low =remote
Low =block print
*
Model Number Dependent
-20-
These tables are only used for programming the CN63100 models.
Use the tables on page 21 if you are programming a CN63300.