Omcan MM-IT-0180, Инструкция по эксплуатации

Страница: 9 / 20

9
Installation
Operation
CONNECTING TO ELECTRICITY SUPPLY
ATTENTION!
Check the electricity supply corresponds to the value given on the appliance ID plate. Electrical works can
only be carried out by specialized and authorized staff with prior authorization by the person in charge of the
appliance. Connect the appliance to a circuit provided with an efficient earth socket. If necessary use suitable
extension leads guaranteeing safety. The section (thickness) of the extension lead must be greater than the
appliance power supply cable. This avoids any hazardous overheating. Avoid pulling or twisting the power
cable as this can damage the internal wires.
The mixer is provided with a 2.5 m power supply cable. This cable has a 4x1,5 mm section (thickness).
Connect the power cable to a three-phase electricity supply and connect a suitable thermo-magnetic
differential switch. Always connect the ground cable.
MOUNTING UTENSILS
To mount the utensil (mixing blades) invert the procedure described in the foregoing paragraph and make sure
the mixing blades are mounted correctly. To facilitate this operation there are numbers stamped on the mixing
blades and on the pins on the inside of the bowl. The number on the blade must correspond to the number on
the pin. Once the mixing blades have been mounted close the grille.
LIST OF CONTROLS AND INDICATORS (FIG. 4.1.2)
1. Drive push-button (continuous).
In stainless steel.
Press to start the blade.
2. Stop push-button.
Press to stop the propeller transmission motor.
3. Reverse drive push-button.
In stainless steel.
Press to start the blade in opposite direction to pus-button “1”.
4. Network presence indicator light.
Signals that the machine is connected to the electrical network.
5. Drive indicator light.
Signals that the tool of the machine is in movement.
Located close to the start push-button “3” and close to the reverse drive push-button “3”.
Visible only when the control is operating.